![]() ![]() ![]() height actually) and the bolt patterns look similar to the others (from photos, none of these mfrs publishes the actual bolt pattern dimensions that I could find - same for the tables btw)ĥ) Kits: Sawstop RT-FS includes the cast iron table, stand with wheels, generic fence and power switch. An Amazon reviewer complained the Sawstop table didn't fit their Kreg stand - was puzzled by this as the Kreg is also 28x20x35 (adj. However the bolt patterns are not listed. Both cast iron tables can be bought in a kit that includes a side-mounted fence, so I'm guessing (hoping) this means the TA Fence will bolt right onĤ) Stand: typically 28x20x35. Not sure about Jet tableģ) Side-mounted fences: do they all use the same 4-hole pattern? I do not wish to drill/tap a brand new cast iron table. However, Sawstop RT-C32 depth is 1/2" compared to phenolics at 3/8" so some customers complain they would prefer longer alignment screws. What I've gathered so far:ġ) Cast Iron Tables: Sawstop RT-C32, Jet 737002 - are there others?Ģ) Router lift: fit is no problem, all are standard 9 1/4 x 11 3/4. Looking for a 32x24 cast iron table top that will fit Jessem TA Fence, Jessem Mast-R-Lift II, and either Jessem, Rockler, Kreg, or SawStop stand (the 4 stands I've found so far). Difficult to find accurate info on mix-n-match router table components, hoping someone has experience to share. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |